Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterGarage Door Before & After in Hollywood, FL
It’s one thing to read a list of services. It’s another to see what a torsion spring replacement actually looks like on a 2009 Clopay in Emerald Hills, or how a new opener changes the way a door moves on a home off Sheridan Street. We document every job with photos before we touch anything and after we’re done. That record isn’t just for us. It’s for you, and it’s included on every visit.
Recent Transformations
Torsion Spring Replacement: Hollywood Hills
The problem: the garage door would not open. The spring had failed overnight, and the opener was straining against a dead weight. Once we checked the assembly, the cause was clean and measurable. The torsion spring had snapped mid-coil, and the remaining tension was gone. That’s a standard but serious failure. It is also dangerous to work around, because the torsion is still stored in half of the spring. We replaced both springs as a matched pair, set the wind to the door’s exact weight, and ran the balance test. The after photo shows a door that lifts with two fingers. The customer received a written price before we started and a photo record of the broken spring on the bench before it went into the truck.
Garage Door Opener Replacement: West Park
The problem: the opener would hum and then do nothing. The logic board had stopped sending the run command, which is a common end-of-life failure on units from that era. We quoted a new LiftMaster rather than a board swap, and the difference is visible in the after photo. The new unit mounts tighter to the ceiling, operates noticeably quieter, and includes a battery backup that the old one never had. The customer asked if we could reuse the old rail. We checked it, and we could, but it would have put a 2024 motor on a 2012 rail with worn trolley wheels. The written scope showed both options. They chose the full replacement, and the photo record shows the fresh rail, the new safety sensors, and the wall console installed at eye level.
Full Door Replacement: Driftwood
The problem: the door was hard to open by hand, even with the spring recently replaced. The track itself had been installed at an angle years ago, and every panel carried rust at the base. You can see it in the before photo, especially along the bottom panel where salt air and storm surge have a way of finding Miami-Dade steel. We replaced the entire system: door, track, hinges, rollers, and weatherseal. The customer wanted a door that would not fight them, and the after photo shows exactly that. The new Clopay door closes with a soft drop and seals against the concrete. The written price included disposal of the old door and a photo record of every component we installed.
Garage Door Parts: Emergency Service in Emerald Hills
The problem: the door was stuck halfway open, and one cable looked like a rope about to snap. It had been fraying for months, and when the customer called, the door was already off balance. A cable under that much tension is not something to handle yourself, and we told the customer to leave the door alone until we arrived. We replaced both cables as a pair, checked the drums for wear, and set the tension. The after photo shows the new cable spooled evenly on the drum. The customer received the written price on the spot, the photo record at the end of the visit, and a door that lifts straight and smooth. No surprises, just a spring and cable system doing what it is supposed to do.
Garage Door Opener Repair: Royal Poinciana
The problem: the door would start closing and then reverse for no apparent reason. The customer assumed the opener was dying. It was not. The safety sensor on the left side had been knocked loose by a trash bin, and it was angled just enough to break the beam. The before photo shows the sensor hanging off its bracket, pointing at the wall instead of across the door. We realigned both sensors, replaced the broken bracket, and ran the obstruction test three times. The after photo shows the sensor fixed flat and secure. The customer paid for a parts and labor call, not a new opener. The written price they got was the price they paid, and the photo record makes the diagnosis easy to understand.
Want Results Like These?
We have worked on 18,000+ garage doors since 2015, and every one of them started with a written price and ended with a photo record. If your door is stuck, sagging, or just too loud, call (754) 465-7645. We answer live, 24/7, and we’ll name the technician before we hang up.
Written by Marcus Deller, Owner at Servo Garage Doors Hollywood, serving Hollywood since 2015.